Reset a region to a saved state!

Discussion in 'Plugin Requests' started by omen19, Apr 19, 2015.

Thread Status:
Not open for further replies.
  1. Offline

    omen19

    I would like to select a region in-game then save it. Then daily after 24 hrs the plugin would reset the region to that saved state!
     
    Last edited by a moderator: Apr 19, 2015
  2. Offline

    au2001

    @omen19 Would it reset it automatically or with a command?
    Because you could simply use WorldEdit and save a schematic then re-load it and paste it.
     
  3. Offline

    omen19

    Ya auto but if that dosen't work I would appreciate if you could teach me how to do dat
     
  4. Offline

    au2001

    @omen19
    Well, WorldEdit is very simple:
    1. //wand
    2. Right click a corner of your area and left click the opposite corner
    3. //copy (remember where you are)
    4. //schem save MySavedArea

    Then, when you want to put it back :
    5. //schem load MySavedArea
    6. Go back to where you where when you did //copy
    7. //paste
     
  5. Offline

    NoLife

    I have not used the plugin so much, but i think it will work ;) RegenBlock
     
  6. Offline

    nverdier

    If it did, please remember to mark this as solved!
     
  7. Offline

    RichardBob123

    A really good rollback system is called Prism. I highly suggest using it, however it's kinda complicated and can be confusing at times. Just read up on it and you should be able to set it up using mySQL. This is the link to the bukkit page on it, and here is the official site.
     
Thread Status:
Not open for further replies.

Share This Page